A side gate should make access simpler, not harder
Made for awkward widths
Non-standard openings are measured properly so the gate suits the actual passage.
Clearances planned in advance
We account for paths, walls and ground levels to help avoid dragging and clashes.
Locks where they make sense
Latch height and locking position are planned around everyday use of the gate.
Secure the passage without fighting the space
A side gate often deals with the awkward bit of the property: the narrow run between house and boundary where bins, bikes, garden tools and the only route to the back all compete for space. A made-to-measure metal side gate helps secure that passage, control access to the rear garden and add privacy where neighbours, paths or shared approaches sit close by. Because these openings are rarely standard, Wingfield Fencing Ltd measures around walls, fence lines, paving, drainage covers and changes in ground level before deciding the best size and clearances.
You can choose a more open design or a more private one, along with the height, latch position, locking arrangement and preferred direction of opening.
The supports matter as much as the gate
Plenty of side gate problems start with the supports rather than the gate itself. If posts, hinges or clearances are wrong, the gate drags, twists or becomes awkward to lock. We look at the whole passage so the gate opens comfortably and lands where it should without fouling paths or boundaries. This service keeps the focus on pedestrian access. If you need something wider for vehicles or a more decorative front entrance, we'll guide you to the driveway gate or decorative gate route instead.
Frequently asked questions
Can you make a side gate for a narrow or uneven gap?
Yes. That is exactly where made-to-measure work helps. We can account for odd widths, wall lines, paving changes and tight clearances, then fabricate the gate around those site conditions instead of trying to trim a standard gate to suit.
Should a side gate open inwards or outwards?
That depends on the space available, the path layout and how you use the passage. We look at where the gate will land, whether it blocks anything important and which direction gives the cleanest everyday use without awkward manoeuvring.
Can a metal side gate include a lock?
Yes, locking can be part of the specification, but the best arrangement depends on the design, the height of the gate and how often it is used. We discuss latch and locking needs early so the gate is built around practical daily access as well as security.